SYNTEKO NOVA BEST 5

Synteko Nova Best 5 is a two-component, water-based, low-odour, non-yellowing polyurethane hardwood timber floor finish for use in high traffic commercial areas.

The unique feature of Synteko NOVA BEST 5 is that it keeps the timber natural looking as if there was no coating on the floor. This can be used on untreated or previously finished timber surfaces.
Synteko Nova Best which is NMP-free is an environmentally friendly timber floor finish with extremely low VOC’s, yet is very hard and user friendly. In addition it has an extended open coat time to facilitate application. This finish is highly desirable because it emphasises the timber’s natural colour.

SYNTEKO TOP 5

Synteko Top 5 is a one-component, non-yellowing water-based, NMP-free low-odour finish for hardwood timber floors.

The unique feature of Synteko Top5 is that it keeps the timber natural looking as if there was no coating on the floor. This can be used on untreated or previously finished timber surfaces.

Synteko Top 5 gives good resistance to wear, scratching, scuffing, marring and chemicals and is therefore ideal for surfaces subject to medium wear in residential and office areas.

SYNTEKO FAST SEALER

Synteko Fast Sealer is a fast drying one component sealer for use over natural, unstained wood especially oily resinous wood species when applying water based top coats. Dries in less than 60 minutes insulating wood extractives and preserving the natural rich colours, especially of dark woods. Can be screened back and powders well, no ‘gumming’ up, and provides great build.

Fast Sealer helps reduce grain raise, edge-bonding and the risk of discolouration in oak and other tannin-containing wood species.

Fast Sealer is a low viscosity sealer providing a quick drying for water base application and overlapping marks are generally avoided.

SYNTEKO FAST FILLER

Synteko Fast Filler is a solvent based joint filler to be mixed with saw dust and is easily sanded. This very fast drying filler is developed to be mixed with fine saw dust to form a thick consistent mix giving a good colour match to timber floors. The fast drying solvent mix has minimal danger of causing a reaction especially with older type of coating used before.

Ideally one would use sawdust from the edger or rotary sander of 80g or 100g sandpaper for gaps up to 2mm. For slightly wider gaps one would use courser grit sand paper dust. Synteko filler is trowelled over the floor surface forcing the Filler into the gaps allowing it dry and then sand off the excess.

© 2018 by Top Shelf Flooring Accessories.

  • Facebook Social Icon
  • Instagram Social Icon
  • YouTube Social  Icon