1k turbo.png


Moisture barrier for sales 28 days plus. Solvent free, do not dilute with water or solvent. 2-24 hour wait time before adhesives or levelling. Outside 24 hr period a second coat required with sand seeds. Slabs with RH 95% and dropping. Allow approximately 2 hours for the Mapeproof 1K Turbo to dry and then apply an undiluted coat of Eco Prim T Plus before applying a suitable levelling compound from the MAPEI range.



Two-component, solvent-free epoxy primer used as bonding promoter for products from the MAPEFLOOR range, for consolidating and waterproofing against residual damp on cementitious substrates and as anti-dust impregnator on concrete floors.
Consistency: liquid.
Colour: transparent yellow.
Mixing ratio: comp. A : comp. B = 3 : 1.
Waiting time before laying floors or applying smoothing compound: 24-48 hours according to the surrounding temperature.
Workability time: 90 minutes.
Storage: 24 months.
Application: brush.
Consumption: 0.20-0.30 kg/m².
Packaging: 1 kg (A+B) and 6 kg (A+B) units.

planiseal mr.png


Two component water based epoxy primer and moisture barrier suitable for green concrete and damp substrates


Consistency: liquid.
Colour: light grey - semi gloss when dry, matt when aged

Drying time: 

- recoat in 2-4 hours

- apply finish after 24 hours

- full cure in 7 days

Mixing ratio: comp. A : comp. B = 1 : 1.

Storage: 12 months.
Application: roller
Consumption: 300-400ml/m² per coat

Packaging: 10 litres (A+B) and 20 litres (A+B) units.

moisture proof.png


Moisture Proof is a liquid moisture barrier and densifier for new or old concrete that requires no mixing and is applied simply by pouring & spreading or spraying with a pump up spray pack. A soft broom is required for an even application and to spread out any puddled areas. Moisture Proof deeply penetrates the concrete to form a non-destructive, 100% colloidal gel that provides a permanent concrete moisture barrier that withstands hydrostatic pressure.

densi crete.png


Densi Crete is a 100% pure colloidal silica designed for the protection of new or old concrete. It has zero VOC and provides exceptional concrete waterproofing to new or old concrete. Densi Crete is used to cure, waterproof, densify, purge oil etc and to seal the concrete from any contamination while also being used extensively in the polished concrete industry.

Densi Crete is a one coat spray on application that deeply penetrates into the matrix of the concrete and withstands a minimum of 35mtr of hydro-static pressure, applied on the positive or negative side of concrete structures.